Controller 12-36V 20A (RGB-RGBW-CCT-DIM)

In stock
Regular Price $46.90
  • Buy 2 for Regular Price $45.90 each and save 2%
  • Buy 5 for Regular Price $44.90 each and save 4%
Technical Data
Zones1 Zone
FunctionDimmer, CCT, RGB, RGBW
Input Voltage12-36V DC
Max Power Load12V=240W, 24V=480W, 36V=720W
Output20A = 4 channels, 5A/channel
InputRF 2.4GHz or Push Dim
Operating Temperature-30°C - +55°C
Controller DimensionsL=175mm, W=45mm, H=27mm

This controller (receiver) can be used to control any single-colour or multi-colour 12V, 24V or 36V LED product, such as our strip light.

It can run up to 20A and has 4 output channels (5A max per channel).

The base stations are wirelessly controlled, so you do not need to run signal wires between areas if you are using more than one receiver. The controller re-transmits the signal to neighbouring controllers within 30m distance. You can run products of a different voltage (e.g. 12V and 24V products) from the same remote using multiple controllers.

It will remember the last setting when powered off, even after experiencing a period of power loss. This is so it can be used with a wall switch if needed.

Matching is very easy with a single button press on this controller base and the chosen remote/zone - please see the Supporting Info tab for instructions for use, including how to match a remote to a controller.
Press the match key quickly 3 times after power reset to change the turn on/off speed (choice between immediate and 3 second fade).

This product needs to be accompanied by either a 1-Zone RGB, or 4-Zone RGB Wheel RF Remote Control, or our RGB or RGBW Wall Plate DMX Controller (via RF). It can be matched with up to 10 remotes if required. If using a multi-zone remote, you will need at least one controller for each zone you wish to run, but one remote will operate them all. You can programme multiple controllers to the same zone.

Alternatively, this product can be used with a non-latching (momentary) push-button wall switch/s (not available at LEDstuff).

See the Supporting Info tab for more instructions for use, including how to match a remote to the controller.

Write Your Own Review
You're reviewing:Controller 12-36V 20A (RGB-RGBW-CCT-DIM)
Your Rating

All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.

This item is covered for 24 months from the time of sale.

In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.

Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.

Controller 12-36V 20A (RGB-RGBW-CCT-DIM) is available to buy in increments of 1