Strip Light Digital Chasing 12V - Waterproof
| Dimmable | Yes |
|---|---|
| Input Voltage | 12V DC |
| Power Consumption | 10W /m |
| Brightness | ~500Lm /m |
| IP Rating | IP66 |
| Average Lifetime | 40,000 hours |
| Light Source | 60 x 5050 LEDs /m |
| Light Colour | Red 625nm/Green 515nm/Blue 460nm |
| Beam Angle | ~120° |
| Working Temperature | -20 - 60°C |
| Type | Colour-Changing |
| Cut Length | 16.5mm |
| Dimensions | W=12mm, H=4.2mm. Multiples of 16.5mm (5m max) |
| Driver IC | SH1908 |
This flexible LED strip light is the perfect solution for decorative lighting! It has 60x 5050 LEDs per meter, and each LED is paired with an 1908 driver chip for individual control. This gives the ability to set the colour and brightness for each LED individually via our Digital Strip Controller.
It is constructed with a very flexible circuit conducting strip on which the LEDs are mounted, and comes with an adhesive 3M backing. Once purchased, the strip light can be cut at 16.5mm intervals. These cut lengths can be joined or run from a separate power supply making it very versatile.
Although this strip light is sold in 1m lengths, you may purchase single length multiples of 1m. For example, you may purchase a single 3m length.
We are unable to supply a single length longer than 5m. If you purchase a quantity more than 5, please specify the lengths you require, otherwise we will make it up with 5m lengths where possible.
Note: This strip runs from 12V DC, so it requires a 12V power supply like our other strip light. See our range of power supplies here.
If you require custom lengths (multiples of 16mm), purchase a Strip Light Wiring Service for each additional length, and specify the lengths you require in the comments field during the checkout process.
If cutting the strip to length yourself, you will need additional end caps to re-waterproof the cut ends, combined with clear or translucent silicone. Purchase the end cap packs here. We recommend Selleys Roof & Gutter Translucent as a waterproofing silicone, which is available from most hardware retailers.
This strip is waterproof. If you require a non-waterproof version, see it here.
This strip has a 3-wire input: positive, negative, and data. An extra positive and negative can be wired to the start of a new roll so that it can be powered separately. The data line is taken from the end of the previous strip, so that they act like a continuous section. The total length that can be run will depend on the controller used - our music controller can control up to 1000 ICs (approx. 16.6m).
PLEASE NOTE: THIS STRIP LIGHT IS DIRECTIONAL - THE DATA WILL ONLY RUN ONE WAY ALONG THE STRIP. THERE ARE SMALL WHITE ARROWS PRINTED ON THE PCB AND THE POWER/CONTROLLER MUST BE CONNECTED AT THE CORRECT END.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.
