Strip Light Continuous COB 12V - RGB

Priced per meter. Run up to 5m in a single length.

This flexible COB (Chip on Board) LED strip light is perfect for background lighting, lighting in cupboards, and decorating your home. Its continuous design makes it ideal for installing in places where you don't want to see the dots of the individual LEDs, such as under cupboards above benches. It is constructed with a very flexible circuit conducting strip which the LEDs are mounted on and comes with an adhesive 3M backing.

This strip is also available in 24VDC, allowing longer runs without voltage drop. It is an RGB colour-changing strip, and therefore needs to be paired with an RGB controller to operate.

It has a thin white bounding wall on either side of the strip, which narrows the spread of light. Our other COB strips have a 170° beam angle, whereas our RGB COB only has 120° beam.

Once purchased, the strip light can be cut at 27.7mm intervals, and cut lengths can be joined or run from a separate power supply making it very versatile.

Although this strip light is sold in 1m lengths, you may purchase single length multiples of 1m. For example, you may purchase a single 3m length.

Please note that we are unable to supply a single length longer than 5m. If you purchase a quantity more than 5, please specify the lengths you require, otherwise we will make it up with 5m lengths where possible.

If you require custom lengths (multiples of 27.7mm) made up from your purchased amount, purchase a strip light wiring service for each additional length and specify the lengths you require in the comments field during the checkout process. For example, if you purchase 2m in total and want 1x 1.1m and 1x 0.9m lengths, just purchase 1x wiring service (1x wiring service is already part of the strip light length) and specify this in the comments field during checkout.

For a modern and clean look, install this strip light in one of our aluminium strip light channels.

Please take care when installing this strip - gently dab your fingers along the length to ensure good adhesion. Don't run your fingers along it, as this can damage the LEDs and cause dark spots.