Mini In-Line RGB Controller with RF Card Remote (Only 12 remaining)

This mini in-line RGB controller is designed for controlling resistor-based LED product, such as our RGB strip light. It is capable of driving up to 6A, so it can run up to 72W of lighting at 12V DC and 144W at 24V DC.

The controller comes with an RF key card remote which takes 1x CR2032 button cell battery (included). The remote will remember its last setting, even after loss of power. Upon powering up from the power source (not the controller), the lights will flash briefly once to indicate that power is connected. Then the remote can be used to turn it on.

If using more than one remote or powering separate strips in the same house, use the following instructions to pair/unpair the remotes as needed:

• To Pair the remote to the controller/strip, power on and press the match button on the controller base, followed by the power button on the remote control. The lights will flash white to show the pairing has been successful
• To Un-pair the remote to the controller/strip, power on and press and hold the match button on the controller base for 5 seconds. The inidcator light next to the match button will flash flash a few times to show the pairing has been successful. Please note that this will delete ALL matched remotes, and therefore you will need to re-match any remaining remotes as desired.
• You can pair a single remote to multiple controller bases, and also pair many remotes to a single controller base if required.

The controller bases are also able to be used with our larger 4-Zone Remote Controls, if you would like to control multiple zones separately from a single remote control.