Card Remote for Mini In-line RGB Controller

In stock
SKU
LED-CONMINRGBR
Regular Price $5.90
Technical Data
Zones1 Zone
FunctionRGB
Remote Range>15m
Remote Frequency433.92MHz
Remote Battery1x CR2025
DimensionsW=40mm, L=86mm, W=7mm

This is a replacement remote for our CONMINRGB Mini In-line RGB Controller. It is also the remote that goes with our RGB Strip Light Kits, so if your remote is lost or damaged, you can easily replace it.

The RF card remote takes 1x CR2025 button cell battery (included). The remote will remember its last setting, even after loss of power. Upon powering up from the power source (not the controller), the lights will flash briefly once to indicate that power is connected. Then the remote can be used to turn it on.

If using more than one remote or powering separate strips in the same house, use the following instructions to pair/unpair the remotes as needed:

  • To pair the remote to the controller/strip, power on and within 5 seconds short press the COLOUR- and BRIGHT- buttons together. The lights will flash white to show the pairing has been successful
  • You can pair a remote to multiple controllers. There is no unpairing function, but you can pair a remote with another controller to undo the first pairing

Write Your Own Review
You're reviewing:Card Remote for Mini In-line RGB Controller
Your Rating

All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.

This item is covered for 24 months from the time of sale.

In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.

Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.

Card Remote for Mini In-line RGB Controller is available to buy in increments of 1