Wall Light Slanted Up-Down - 2x3W 230V
Dimmable | No |
---|---|
Housing Colour | Black |
Input Voltage | 85-265V AC |
Power Consumption | 6W |
Output | 540Lm |
Efficiency | 90Lm /W |
Light Source | 2x3W COB LEDs |
Beam Angle | 100° up and down |
Light Colour | Warm White (3000K) |
IP Rating | IP65 |
CRI | RA >80 |
Material | Aluminium Alloy |
Weight | 600g |
Dimensions | L=215mm, W=125mm, D=64mm |
SDoC | Available on Request |
This outdoor light fitting has a stylish slanted design and looks great as a feature on exterior walls or columns. It is built from robust aluminium alloy with black powder-coating in a textured matte finish. It has two 3W COB LEDs, one on either end, which shine upwards and downwards with a slanted fixed 100° spread of light in each direction. This fitting runs from 230V AC and draws a total of 6W. It outputs 540 lumens of Warm White light.
Rated IP65, these units are waterproof, dust tight, and protected from water jets. Ensure the rubber seals located where the wires exit at the rear of the unit, and between the rear panel and the main unit are in place to ensure it is watertight. The unit is earthed by grub screws to the casing.
Each fitting comes with 2x screws, nylon screw anchors, a screw terminal connector block, and a hex tool.
This is a 230V AC product and should be installed by a qualified electrician. Refer to the installation instructions. Ensure the grub screws are secured as tightly as possible to ensure the product is earthed.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.