Strip Light Continuous COB 24V - Digital Chasing

In stock
SKU
LED-SLCOBN24DIG-CONFIG
Special Price $38.17 Regular Price $44.90
Technical Data
DimmableYes
Input Voltage24V DC
Power Consumption15W /m
Brightness~500Lm /m
IP RatingIP20 (Non-Waterproof)
Average Lifetime40,000 hours
Light Source528 COB LEDs
Light ColourRed 625nm/Green 515nm/Blue 460nm
Beam Angle~120°
Working Temperature-20 - 60°C
TypeColour-Changing
Cut Length100mm
DimensionsW=10mm, H=2.2mm. Multiples of 100mm (5m max)
Driver ICWS2811

This flexible COB LED strip light is the perfect solution for decorative lighting! It has the continuous look of a traditional COB strip, but it chases when used with a digital controller. It is cuttable every 100mm, so each 'Pixel' is 100mm long. Digital control gives the ability to set the colour and brightness for each pixel individually via our Digital Strip Controller.

It is constructed with a very flexible circuit conducting strip on which the LEDs are mounted, and comes with an adhesive 3M backing. Once purchased, the strip light can be cut at 100mm intervals. These cut lengths can be joined or run from a separate power supply making it very versatile.

Although this strip light is sold in 1m lengths, you may purchase single length multiples of 1m. For example, you may purchase a single 3m length.

We are unable to supply a single length longer than 5m. If you purchase a quantity more than 5, please specify the lengths you require, otherwise we will make it up with 5m lengths where possible.

Note: This strip runs from 24V DC, so it requires a 24V power supply like our other strip light. See our range of power supplies here.

If you require custom lengths (multiples of 100mm), purchase a Strip Light Wiring Service for each additional length, and specify the lengths you require in the comments field during the checkout process.

This strip is non-waterproof - we do not currently stock this strip in a waterproof option.

This strip has a 3-wire input: positive, negative, and data. An extra positive and negative can be wired to the start of a new roll so that it can be powered separately. The data line is taken from the end of the previous strip, so that they act like a continuous section. The total length that can be run will depend on the controller used - our digital controller can control up to 1000 ICs (approx. 100m in this strip).

PLEASE NOTE: THIS STRIP LIGHT IS DIRECTIONAL - THE DATA WILL ONLY RUN ONE WAY ALONG THE STRIP. THERE ARE SMALL BLACK ARROWS PRINTED ON THE PCB AND THE POWER/CONTROLLER MUST BE CONNECTED AT THE CORRECT END.

Write Your Own Review
You're reviewing:Strip Light Continuous COB 24V - Digital Chasing
Your Rating
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship. This item is covered for 24 months from the time of sale. In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable. Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.
Strip Light Continuous COB 24V - Digital Chasing is available to buy in increments of 1