Solar Sensor Flood Light 2-Way Tiltable
| Housing Colour | Black |
|---|---|
| Light Colour | Cool White (6500K) |
| Batteries | 18650 (2200mAh) |
| Light Source | 56x 2835 SMD LEDs |
| Modes | Dim, turns bright when motion detected |
| Solar Panel | 5.5V 1.5W |
| Charge Time | 8 hours |
| Motion Detection Distance | 6m |
| Output | 120Lm |
| IP Rating | IP65 |
| Weight | 0.40kg Net, 0.45kg Gross |
This 2-way tiltable solar flood light can be used to illuminate a small outdoor area. It has a built in PIR motion and light sensor, and will automatically turn on to low brightness at dusk and turn off at dawn. It will also turn to full brightness for 30 seconds when motion is detected, before returning to low brightness. The sensor will detect motion from as far as 6m away.
It is recommended to charge this light for 2-3 sunny days before the first use. Then use the supplied pin to activate the light (you only need to do this once). When low on power, the light will flash to indicate low battery, before switching off.
The two light panels can rotate 150 degrees horizontally, and 180 degrees plus vertically (depending on the angle of the solar panel). The solar panel itself can rotate vertically 50 degrees, and horizontally 220 degrees.
Install with the solar panel facing north and in a position where it will receive the most possible sunlight. It requires approximately 8 hours of good sunlight to fully charge, and should last all night. It comes with hardware for mounting (screws, plugs, and wall panel).
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.