Power Supply Triac Dimmable 12V 300W (Only 2 remaining)
- Buy 3 for Regular Price $449.90 each and save 8%
| Input Voltage | 180-240V AC 50/60Hz |
|---|---|
| Output | 12V 25A (300W) |
| Efficiency | 89% |
| Loading Range | 5-100% |
| Dimensions | L=276mm (incl tabs), W=78mm, H=46mm |
| IP Rating | IP66 |
| Wire Length | Input L=205mm, Output L=205mm |
| Weight | 1.65Kg |
| Standards | SELV (Safety Extra Low Voltage) |
| SDoC | Available on request |
This is a constant voltage AC-DC power supply for powering LED lighting such as our MR16 bulbs and strip light. This DC power supply takes 230V mains and outputs a regulated 12V DC up to a maximum load of 300W (25A).
This is a dimmable supply with Triac Dimming technology on forward-phase (Leading edge). It can be used with our KIWI Electronics mains wall dimmer with no restrictions. It is not compatible with HPM dimmers.
The power supply itself is waterproof with an IP66 rating. The unit has 3-core flying wires out the mains input end, and two sets of 2-core flying wires out the 12V DC output end, and each are clearly labelled for wiring, however you must make sure that it is installed by a qualified electrician if hard-wiring in, so the mains connections are safe.
A replacement supply like this is often required if you are substituting 12V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.
Please read installation instructions fully before attempting any work.
Supplier Declaration of Conformity (SDoC) is available on request - please contact us.