Power Supply 24V 4.17A 100W (Only 12 remaining)
| Input Voltage | 170-265V AC 50/60Hz |
|---|---|
| Output | 24V 4.17A (100W) |
| Efficiency | 85% |
| Power Factor | 0.8 |
| Working Temperature | < 60°C |
| Dimensions | L=218mm (242mm incl. tabs), W=68mm, H=55mm |
| IP Rating | IP67 |
| Weight | 1.15Kg |
| SDoC | Available on request |
This item is end of line - limited stock remaining!
This is a constant voltage AC-DC power supply for driving LED lighting such as our MR16 bulbs and strip light. This supply takes 230V mains and outputs a regulated 24V DC up to a maximum load of 100W (4.17A).
The power supply itself is waterproof with an IP67 rating, however you must make sure that it is installed by a qualified electrician so the mains connections are safe. The unit has flying wires out each end and is clearly labelled for wiring.
A replacement supply like this is often required if you are substituting 24V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.
Please read installation instructions fully before attempting any work.
Supplier Declaration of Conformity (SDoC) is available on request - please contact us.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.