Power Supply 24V 3.2A 75W - ENVO Non-Waterproof
| Input Voltage | 200-240V AC |
|---|---|
| Output | 24V 3.2A (75W) |
| Efficiency | 89% |
| Working Temperature | -20°C - +45°C |
| Dimensions | L=170mm, W=45mm, H=28mm |
| Weight | 260g |
| Standards | SELV (Safety Extra Low Voltage) |
| SDoC | Available on request |
This is a constant voltage AC-DC power supply for powering LED lighting such as our MR16 bulbs and strip light. This DC power supply takes 230V mains and outputs a regulated 24V DC up to a maximum load of 75W (3.2A).
The power supply itself is non-waterproof. The unit has screw terminals at each end and is clearly labelled for wiring.
A replacement supply like this is often required if you are substituting 24V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.
Please read installation instructions fully before attempting any work.
This power supply is for indoor use only. However, you can run the 24V side outside: 24V is a safe voltage to run outdoors.
This power supply is part of the ENVO series.
Supplier Declaration of Conformity (SDoC) is available on request - please contact us.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.