Power Supply 24V 10A 240W - Meanwell ELG Series
- Buy 5 for Regular Price $192.90 each and save 4%
|Input Voltage||100-240V AC 50/60Hz|
|Output||24V 10A (240W)|
|Working Temperature||< 60°C|
|Dimensions||L=245mm (incl. tabs), W=71.5mm, H=37.5mm|
|Wire Length||Input L=1855mm, Output L=295mm|
|Standards||SELV (Safety Extra Low Voltage)|
|SDoC||Available on request|
This is a constant voltage AC-DC power supply for powering LED lighting such as our MR16 bulbs and strip light. This DC power supply takes 230V mains and outputs a regulated 24V DC up to a maximum load of 240W 10A).
The power supply itself is waterproof with an IP67 rating. The unit comes with a 3-pin plug injection moulded to the input wire, making installation easy, however you must make sure that it is installed by a qualified electrician if hard-wiring in, so the mains connections are safe.
A replacement supply like this is often required if you are substituting 24V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.
Please read installation instructions fully before attempting any work.
This power supply is part of the Meanwell ELG series, which are SELV rated and are recommended for commercial jobs. They are constructed using metal casing, 3-wire input with earth and 2-wire DC output. The 100W to 240W models come with a moulded 3-pin plug on a 1m lead, while the 60W to 80W models come with a bare wire lead (purchase our 3-pin plug wiring service if you require a plug on these models).
Supplier Declaration of Conformity (SDoC) is available on request - please contact us.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.