Power Supply 12V 3A 35W - Meanwell LPV Series (Only 2 remaining)
- Buy 5 for Regular Price $54.90 each and save 4%
- Buy 10 for Regular Price $52.90 each and save 7%
|Input Voltage||90-264V AC or 127-370V DC 47/63Hz|
|Output||12V 3A (36W)|
|Working Temperature||-30 - +65°C|
|Dimensions||L=148mm, W=40mm, H=30mm|
|SDoC||Available on request|
This is a constant voltage AC-DC power supply for powering LED lighting such as our MR16 bulbs and strip light. This DC power supply takes 230V mains and outputs a regulated 12V DC up to a maximum load of 36W (3A).
The power supply itself is waterproof with an IP67 rating, however you must make sure that it is installed by a qualified electrician so the mains connections are safe. The unit has flying wires out each end and is clearly labelled for wiring.
A replacement supply like this is often required if you are substituting 24V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.
Please read installation instructions fully before attempting any work.
This power supply is part of the Meanwell LPV series, which are ideal for residential applications. They are constructed with a plastic case, 2-wire input and 2-wire DC output. Most models come with bare wire leads for hard-wiring, except for the 100W, 120W and 150W models that come with a moulded 2-pin plug with 1m lead attached. If you require a commercial grade supply that will be operating for long hours, then please see our SELV rated ELG range of Meanwell power supplies.
Supplier Declaration of Conformity (SDoC) is available on request - please contact us.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.