Power Supply 12V 3.3A 40W - Thinkwise (Only 2 remaining)

In stock
Only 2 left
Regular Price $89.90
  • Buy 5 for Regular Price $84.90 each and save 6%
Technical Data
Input Voltage220-240V AC 50/60Hz
Output12V 3.3A (40W)
Working Temperature-20°C to +50°C
DimensionsL=165mm, W=52mm, H=25mm
IP RatingIP20
StandardsSELV (Safety Extra Low Voltage)
SDoCAvailable on request

This is a constant voltage AC-DC power supply for powering LED lighting such as our MR16 bulbs and strip light. This DC power supply takes 230V mains and outputs a regulated 12V DC up to a maximum load of 40W (3.3A).

The power supply itself is non-waterproof with an IP20 rating, however you must make sure that it is installed by a qualified electrician so the mains connections are safe. The unit has screw terminals at each end and is clearly labelled for wiring.

A replacement supply like this is often required if you are substituting 12V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.

Please read installation instructions fully before attempting any work.

This power supply is for indoor use only. However, you can run the 12V side outside: 12V is a safe voltage to run outdoors.

This power supply is part of the MEAN WELL Thinkwise series.

Supplier Declaration of Conformity (SDoC) is available on request - please contact us.

Please note photos are indicative only, this is the 12V model, which looks the same as the 24V.

Write Your Own Review
You're reviewing:Power Supply 12V 3.3A 40W - Thinkwise (Only 2 remaining)
Your Rating

All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.

This item is covered for 24 months from the time of sale.

In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.

Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.

Power Supply 12V 3.3A 40W - Thinkwise (Only 2 remaining) is available to buy in increments of 1