Card Remote for Mini In-line Controller
Zones | 1 Zone |
---|---|
Function | Dimmer |
Remote Range | >15m |
Remote Frequency | 433.92MHz |
Remote Battery | 1x CR2025 (included) |
Dimensions | W=40mm, L=86mm, W=7mm |
This is a replacement remote for our CONMINR Mini In-line Controller, so if your remote is lost or damaged, you can easily replace it.
The RF card remote takes 1x CR2025 button cell battery (included). The remote will remember its last setting, even after loss of power. Upon powering up from the power source (not the controller), the lights will flash briefly once to indicate that power is connected. Then the remote can be used to turn it on.
If using one remote for multiple controllers, use the following instructions to pair the controllers as needed:
- To pair the remote to the controller/strip, power on and within 5 seconds short press the SPEED+ and SPEED- buttons together. The lights will flash white to show the pairing has been successful
- There is no unpairing function, but you can pair a controller with another remote to undo the first pairing
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.