4 Zone 4-in-1 Controller Set 12/24V 24A

This 4 Zone 4-in-1 controller set includes 1x controller and 1x remote. It can be used to operate compatible 12V or 24V single colour, RGB, RGBW, and/or Colour Temperature Adjustable (CCT) LED products, such as strip light. It has 4 zones (or channels) which can be operated independently using the remote.

This controller remembers its last setting, even when power is switched off to the unit, so that it can be used with a wall switch.

Each base can be set to drive a different type of light, which can all be controlled from the same remote, meaning that you no longer have to have a separate remote to control your RGB/RGBW lighting from your single colour and colour temperature adjustable lighting!

The base stations are wirelessly controlled, so you do not need to run signal wires between areas, and you can run 12V products and 24V products from the same remote.

Please note that base stations cannot be purchased separately, which means that if you require up to 4 bases, you will have multiple remotes. Multiple remotes can be programmed to sync together, so they can be located at different parts of the house while controlling the same bases.

This RF remote has a range of 20m and will operate through walls and other barriers inside your home. It comes with a wall-mountable cradle, screws and nylon screw anchors (wall plug/rawlplugs) and double-sided foam tape. It takes 2x AAA batteries, which are included.

For the RGB/RGBW bases, the colour ring has 64 static colour steps available, and there are 6 set static colours that can be scrolled between with the + and - keys. There are 8 automatic colour changing modes to choose from using the M key. The brightness and speed of the changing modes can be adjusted, and each zone can be set individually or together. The W key sets the RGB lighting to its combined white mode directly, while for RGBW lighting it turns on the dedicated white LED chip/s.

For single colour products, the colour wheel becomes the dimmer wheel – dim down by running your finger around in a clockwise direction, and for Colour Temperature Adjustable (CCT) products, the colour wheel then adjusts the colour between Warm White and Cool White. There are also fading and flashing modes, and the speed of these can be adjusted using the speed keys. The brightness can be adjusted quickly using the + and – keys, or more finely using the brightness + and – keys. The ‘W’ key becomes Night Light mode, setting the light level to 10% brightness until the setting area modified again.