Wall Touch Plate RGB Controller 3x 4A

In stock
Only 2 left
Regular Price $89.90
  • Buy 2 for Regular Price $86.40 each and save 4%
  • Buy 5 for Regular Price $83.90 each and save 7%
Technical Data
Input Voltage12-24V DC
Operating Life50,000 hours
Max Current12A (total)
Standby Power Consumption0.4W
Controller DimensionsH=86mm, W=86mm, D=36mm

This wall plate RGB controller is designed for controlling any 12V or 24V RGB colour-changing product, such as our LED RGB strip light. It has a clean modern look with its glass touch panel, and it emits a pleasant sound to indicate when a touch has registered - however this can be turned on/off (muted) simply by pressing and holding the power button until it sounds. A blue indicator light shows just above the power button when the unit is powered off so that it is easy to locate in the dark.

Run up to 4 lengths of strip/low voltage products, each up to 3A load each - the maximum output of this controller is 4A per channel (12A max total).

Please note that this does not fit into a standard wall socket box. It is supplied with an 86 type switch box which is installed into the wall beforehand - this product is recommended for new builds or renovations where new GIB board will be installed. Retrofitting an 86 box into the wall will be difficult as the touch panel only just covers the hole the panel is recessed into. This unit comes with mounting screws.


The top arrow keys change the brightness of a single colour up and down, or change the speed of fade/flash between colours in the colour changing modes. If you want a colour changing sequence brightness to be dimmed, this must be set on a single colour mode first, followed then by selecting the colour changing mode. It can also be programmed to remember your favourite setting as a 'scene', so that it can be easily set back to this after it has been changed. Set it to a specific colour at any time simply by selecting the desired colour on the colour wheel dial. Change to a mode and scroll through the different modes by pressing the mode key on the bottom left corner. This will also jump back to the last mode set when pressed after having set a single colour on the colour wheel dial.

Modes available:

  • Static Red
  • Static Green
  • Static Blue
  • Static Yellow
  • Static Purple
  • Static Cyan
  • Static White
  • RGB (3 colours) jumping/flashing
  • 7 colours jumping/flashing
  • RGB (3 colours) smooth fading
  • 7 colours smooth fading

Use this controller with our flexible RGB strip light.

Write Your Own Review
You're reviewing:Wall Touch Plate RGB Controller 3x 4A
Your Rating

All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.

This item is covered for 24 months from the time of sale.

In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.

Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.