Wall Touch Plate Dimmer 3x 4A

In stock
Only 1 left
Regular Price $69.90
  • Buy 2 for Regular Price $67.40 each and save 4%
  • Buy 5 for Regular Price $64.90 each and save 7%
Technical Data
Input Voltage12-24V DC
Operating Life50,000 hours
Max Current12A (total)
Standby Power Consumption0.4W
Controller DimensionsH=86mm, W=86mm, D=36mm

This dimmer unit is designed for controlling any 12V or 24V single colour 2-wire product, such as our LED strip light. Change the brightness up and down using the top arrow keys or by using the touch wheel dial. It features a mode with a turn off 30 second delay, so that you don’t have to exit the room in the dark. It can also be programmed to remember your favourite setting as a 'scene', so that it can be easily set back to this after it has been changed.

It has a clean modern look with its glass touch panel, and it emits a pleasant sound to indicate when a touch has registered - however this can be turned on/off (muted) simply by pressing and holding the power button until it sounds. A blue indicator light shows just above the power button when the unit is powered off so that it is easy to locate in the dark.

Run up to 3 lengths of strip/12V products, each up to 4A load each - the maximum output of this controller is 4A per channel (12A max total). It dims from 5 to 100% brightness. Each length/load is controlled at the same time, so that strip installed in different areas dim at the same time (this controller does not have the ability to control the lengths separately).

Please note that this does not fit into a standard wall socket box. It is supplied with an 86 type switch box which is installed into the wall beforehand - this product is recommended for new builds or renovations where new GIB board will be installed. Retrofitting an 86 box into the wall will be difficult as the touch panel only just covers the hole the panel is recessed into. This unit comes with mounting screws.

Use this controller with our flexible strip light.

Write Your Own Review
You're reviewing:Wall Touch Plate Dimmer 3x 4A
Your Rating

All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.

This item is covered for 24 months from the time of sale.

In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.

Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.