PWM Dimmer with RF Wheel Remote
- Buy 2 for Regular Price $66.90 each and save 4%
- Buy 5 for Regular Price $64.90 each and save 7%
Dimmable | Yes |
---|---|
Input Voltage | 12-24V DC |
Output | 100W at 12V DC, 200W at 24V DC |
Operating Life | 25,000 hours |
Max Current | 10A (Max 6A per channel) |
Standby Power Consumption | 0.1W |
Remote Range | > 30m |
Remote Frequency | 433 MHz |
Weight | 75g |
Controller Dimensions | L=83mm, W=64mm, H=24mm |
Remote Dimensions | L=114mm, W=56mm, H=18mm |
This PWM dimmer is designed for adjusting the brightness of any resistor-based LED product, such as our single colour LED Strip Light or individual LEDs. It is capable of driving up to 10A, so it can run up to 120W of lighting at 12V DC and 240W at 24V DC (maximum 6A per channel). For running even more load, use our PWM Expansion Module.
The controller comes complete with an RF remote control that will work through walls and up to 30m indoors. The remote has a touch sensitive dimmer wheel for immediate control, as well as low/medium/high settings and on/off control. The remote is powered by 2xAAA batteries which are not included.
This controller remembers its last setting, even when power is switched off to the unit, so that it can be used with a wall switch.
Please note: When running a single load of more than 6A, you must bridge the two outputs so that the full 10A loading of the controller can be utilized. Loading more than 6A on a single channel with shorten the lifespan of the unit and cause it to fail.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.