Power Supply 12V 5A 60W - Meanwell XLG Series

In stock
Only 5 left
Regular Price $123.20
  • Buy 5 for Regular Price $112.20 each and save 9%
Technical Data
Input Voltage100-240V AC 50/60Hz
Output12V 5A (60W)
Working Temperature-40 to 85°C
DimensionsL=140mm (incl. tabs), W=64mm, H=32mm
IP RatingIP67
Wire LengthInput L=1840mm, Output L=295mm
StandardsSELV (Safety Extra Low Voltage)
SDoCAvailable on request

This is a constant voltage AC-DC power supply for driving LED lighting such as our MR16 bulbs and strip light. This power supply takes 230V mains and outputs a regulated 12V DC up to a maximum load of 60W (5A). The power supply itself is waterproof with an IP67 rating.

The unit has a 3-pin plug at the mains input end, and 2-Core wires out the 12VDC output end. Each are clearly labelled for wiring, however you must make sure that it is installed by a qualified electrician if hard-wiring in, so the mains connections are safe.

A replacement supply like this is often required if you are substituting 12V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.

Please read installation instructions fully before attempting any work.

This power supply is part of the Meanwell XLG series, which are SELV rated and are recommended for commercial jobs. They are constructed using metal casing, 3-wire input with earth and 2-wire DC output.

Supplier Declaration of Conformity (SDoC) is available on request - please contact us.

Write Your Own Review
You're reviewing:Power Supply 12V 5A 60W - Meanwell XLG Series
Your Rating

All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.

This item is covered for 24 months from the time of sale.

In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.

Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.