Power Supply 12V 0.5A 6W

In stock
Regular Price $14.90
  • Buy 5 for Regular Price $13.90 each and save 7%
  • Buy 20 for Regular Price $12.90 each and save 13%
Technical Data
Input Voltage170-265V AC 50/60Hz
Output12V 0.5A (6W)
Power Factor0.8
Working Temperature< 60°C
DimensionsL=60mm, W=29mm, H=21mm
IP RatingIP67
Wire Length> 200mm
SDoCAvailable on request

This is a constant voltage AC-DC power supply for driving LED lighting such as our MR16 bulbs and strip light. This supply takes 230V mains and outputs a regulated 12V DC up to a maximum load of 6W (0.5A).

The power supply is waterproof with an IP67 rating; however you must make sure that it is installed by a qualified electrician so the mains connections are safe. The unit has flying wires out each end and is clearly labelled for wiring.

A replacement supply like this is often required if you are substituting 12V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.

Note that we are unable to supply the 3-pin plug wiring service for this product - it must be for the 20W power supply or greater.

Please read installation instructions fully before attempting any work.

Supplier Declaration of Conformity (SDoC) is available on request - please contact us.

Write Your Own Review
You're reviewing:Power Supply 12V 0.5A 6W
Your Rating

All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.

This item is covered for 24 months from the time of sale.

In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.

Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.