Power Supply 12V 0.42A 5W - White Shell
|Input Voltage||100-240V AC 50-60Hz|
|Output||12V 0.42A (5W)|
|Working Temperature||< 60°C|
|Dimensions||W=40mm, H=20.5mm, L=57.5mm|
|SDoC||Available on request|
This is a constant voltage AC-DC power supply for driving LED lighting such as our MR16 bulbs and strip light. This supply takes 230V mains and outputs a regulated 12V DC up to a maximum load of 5W (0.42A).
The power supply is not IP rated so it is for indoor use only. The unit has screw terminal connections and is clearly labelled for wiring. It should be installed by a qualified electrician so the mains connections are safe.
A replacement supply like this is often required if you are substituting 12V halogen bulbs with LED bulbs, as halogens are usually run on AC, but most LEDs require DC.
Note that we are unable to supply the 3-Pin plug wiring service for this product - it must be for the 20W power supply or greater.
Please read installation instructions fully before attempting any work.
This power supply is for indoor use only. However it is safe to run the 12V side outside, as 12V is a safe voltage to run outdoors.
Supplier Declaration of Conformity (SDoC) is available on request - please contact us.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.