Infra-Red Hand Motion Sensor Dimmable 12-24V DC 8A (Only 3 remaining)
| Input Voltage | 12-24V DC |
|---|---|
| Current | 8A |
| Output | Up to 96W of 12V, 192W of 24V DC LED lighting |
| Detection Range | <100mm |
| Dimensions | L=55mm, W=10mm |
This item is end of line - limited stock remaining!
This Infra-Red hand sensor switch works to activate and dim any 12 or 24V DC LED. It is designed to be used and installed alongside LED strip light inside an aluminium channel, but could be installed into other enclosures or used 'bare'. It is built into some of our SlimLite range, such as our SlimLite 300mm Hand IR Sensor Light and SlimLite 500mm Hand IR Sensor Light, both of which can be made to custom lengths if required.
It is ideal for use in the home as well as in motorhomes and caravans for automatic lighting. Measuring just 55mm in length, this sensor is very discrete. To operate, simply wave a hand over the light within 100mm of the sensor. To dim, hold your hand over the sensor for 3 seconds, and continue to hold until the desired dim setting is achieved. Repeating this process reverses the dim function and increases the brightness until full brightness is reached.
To install, cut two 5mm holes in the plastic diffuser for the detector head to operate through. Solder the input wire to the V+ and V- at the input end of the PCB board, and the LED strip light to the LED+ and LED- at the output end.
Pricing is per sensor.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.