4 Zone Dimmer Receiver 12/24V 12A
- Buy 3 for Regular Price $46.90 each and save 6%
|Input Voltage||12/24V DC|
|Output||6A max per channel, 12A max total|
|Controller Dimensions||L=90mm, W=48mm, H=24mm|
This 4 Zone receiver can be used to control any dimmable 12 or 24V LED product, such as our strip light.
It can run up to 12A total, 6A per channel. The output channels are not internally bridged on this controller. If you are running more than 6A, please utilise both channels and bridge the positive and negative outputs. View the supporting info tab for a bridging wiring diagram.
The base stations are wirelessly controlled, so you do not need to run signal wires between areas, and you can run 12V products and 24V products from the same remote.
Note this product needs to be accompanied with a 4 Zone Controller Remote. This remote allows you to choose between 4 different zones, and can be used with single colour or CCT controllers, or a mix of both! It can turn them on and off, and dim the lights of the LEDs in each zone independently. You will need at least one controller for each zone you wish to run, but one remote will operate them all. Please see 4 Zone Controller Remote for all the details on its functionality.
All LEDstuff products are supplied with a warranty that the item is free from defects in materials and workmanship.
This item is covered for 24 months from the time of sale.
In the event of a warranty claim, LEDstuff reserves the right to repair or replace the product where applicable.
Faults due to misuse, alteration, normal wear, or accident are not covered under warranty.